Ancon Slot Ties
Ancon PPS/PPB/PPV/PP21 Movement Tie
Debonding sleeves are used on plain-ended wall ties at vertical movement joints. The tie will restrain the masonry against lateral wind loads but the sleeve will allow the masonry to expand or contract. Debonding sleeves should be installed with a 10mm gap at the end to allow for expansion of the masonry.
Ancon SDB Frame Cramps used as cavity wall ties exceed the requirements of a Type 2 tie to PD 6697 for cavities up to 300mm. They have a 7mm diameter hole to suit a range of fixings. Ancon M6 single expansion bolts are recommended for fixing to concrete and M6 set screws or SDTSS-38-5PT self-drilling screws for fixing to steelwork. Ties for Cast-in Slots & Channels Ancon SD21 Tie to suit 21/18 Omega Channel Ancon 21/18 Omega Channel is a high performance, self-anchoring, cast-in channel slot suitable for use with wall ties referenced 21 to provide necessary restraint to the outer leaf of masonry. Ancon SD25 wall ties are available in various lengths to suit open cavities from 35mm to 259mm. They are located in the channel by rotating through 90° and can be easily moved to the required position where they are built into the masonry bed joint. Tie length – 100mm – 225mm Box Quantity – 250. Wall Ties & Restraint Fixings. Technical Information. NZS4210, NZS4230 & AS/NZS2699; Tie Length & Density; Wall Starter Systems; Other Restraint Fixings. Movement Ties; Frame Cramps; Ties for Cast-in Slots & Channels; Head Restraints; Sliding Anchors; Masonry Reinforcement; Wall Ties. Ties for Steel Frames; Restraints for Stone Cladding.
Debonding Sleeve
Debonded Ties require 100mm embedment. A 120mm long sleeve will provide an allowance for movement and tolerance, and will be suitable for most applications. Other lengths and sizes available to special order.
Wall Ties & Restraint Fixings (PDF, 6.97 MB)
Ancon PPS/PPB/PPV/PP21 Movement Tie
Ancon Slot Ties Game
Debonding sleeves are used on plain-ended wall ties at vertical movement joints. The tie will restrain the masonry against lateral wind loads but the sleeve will allow the masonry to expand or contract. Debonding sleeves should be installed with a 10mm gap at the end to allow for expansion of the masonry.
Debonding Sleeve
Debonded Ties require 100mm embedment. A 120mm long sleeve will provide an allowance for movement and tolerance, and will be suitable for most applications. Other lengths and sizes available to special order.